I am ready to go with the code 59 conversion now but have one step left. I have the chip adapter in the ECm and the cable from the APU1. The cable can go into the ZIF socket on the adapter two ways, with the cable laying over the body of the ecm or the cable laying over the side of the ECM. I hope that make sense, I don't know how else to describe it. I need to know what orientation to use?? At one time I found instructions for this on the net somewhere (moates, tunerpro, syty, or here) I can't recall and can't seem to find it now.

Any help would be appreciated.

Chris

Pin 1, inidcated by the red stripe will be at pointing away from where the CALPAK would be, so nearest the edge of the adaptor.

Here is a picture for you....