Hi guys, im not sure if you can help me or not, i've been working on getting the $59 code working on my car ... bit of a run down ...

its a straight 6 cylinder holden motor which has been converted to run on the delco 1227808 ecu and as far as all that goes its working fine. It uses a reluctor type distributor for the pickup and a single coil and ignition module to talk to the ecu. I plan to run the $59 code if possible so i can fit a turbo to the car and use all the nice features this code has.

now i have modified the 1227808 by way of a max232 comms board which solders onto the ecu and basically gives me a serial port on the side of the ecu which i can get 8192 baud data from ... the stock setup for this ecu only allows 160 baud ....

so once i have the ecu to this stage i can get data out of it using the $12 code which is the same as a 16183082 / 16206305 ecu (which from what i understand is supposed to be the same as my modified 1227808) .... anyway thats probably beside the point .... i guess it proves that the interface does work etc ....

i have installed a 3 bar map sensor, and i have been able to get the engine to start and run for a few seconds with a starter bin modified for my referance angle, idle rpms and after increasing the BPC.

so my question is: does anyone know if the 1227808 will work with the $59 code using tunerpro rt to log aldl data ?

i understand if you guys can't help me because this is an australian ecu and you may not have heard about it but i thought it can't hurt to ask!